Connect to motor

10. Measure the required wire length between the fused terminal blocks and the DAQ and cut three extra phase wires to the correct size. Install ferrules on both ends.

11. Open the other connector of the fused terminal block using a screwdriver and install the phase wire in the fused terminal block. 

12. Check on which phase wire the fused terminal block has been installed. Add the corresponding phase marking on the phase wire between the fused terminal block and the DAQ.

13. Connect the wire of the fused terminal block to the corresponding connector on the DAQ using a screwdriver.
Notice Place the fused terminal blocks at least 2 centimeters away from the DAQ to account for Electromagnetic Compatibility (EMC).